Skip to main content

Category: Modem & Router Setup · Last updated 19 Nov 2026

Setting up your D-Link DSL-2888A

How to set up a D-Link DSL-2888A modem on an FTTN or FTTB nbn connection with Lightning IP.

The D-Link DSL-2888A is an older modem router with a built-in VDSL modem. Use this guide to set it up on an FTTN or FTTB nbn connection with Lightning IP.

This modem is fine for everyday use on slower plans, but its older hardware can hold back faster plans. If you're on a faster plan, a newer modem will usually give you better results.

Settings our network needs

SettingWhat to choose
Connection typeDynamic IP
VLAN / VLAN IDOff (untagged)
Username and passwordNot needed

Set it up

  1. Reset the modem With the modem plugged in and switched on, hold the Reset button with a paperclip for about 3 seconds. This clears any old settings.
  2. Connect to the phone socket Plug the phone cable into the grey DSL port and the other end into your wall phone socket. Don't use any line filters or splitters.
  3. Power on Switch the modem on with the Power button.
  4. Connect a device Plug a computer into a yellow ethernet port, or join the modem's Wi-Fi using the details on the label.
  5. Open the setup page In a web browser, go to 192.168.1.1 or dlinkrouter.local.
  6. Start the wizard The setup wizard should open by itself. If you're asked to log in, click Log In (there's no password yet). Click Next and wait while the modem detects your connection.
  7. If it can't detect the connection Set WAN Access Type to VDSL (or xDSL), set ISP to Not Listed, and click Next. Choose Dynamic IP and click Next.
  8. Set up your Wi-Fi Change the Wi-Fi names and passwords if you like, then click Next.
  9. Set an admin password Choose a password for logging in to the modem, then click Next.
  10. Finish Click Finish on the summary page. Allow up to 10 minutes for the modem to connect.

If it doesn't connect

  • DSL light flashing or off - Check the phone cable, remove any filters or splitters, and try another phone socket.
  • Internet light off - Log back in and check the connection type is Dynamic IP with VLAN turned off.
  • Still no luck - Restart your modem properly and follow our no internet connection guide, or get in touch.

Related Articles

Was this article helpful?

Your feedback helps us improve our support content.