---
title: "Setting up your D-Link DSL-2888A"
description: "How to set up a D-Link DSL-2888A modem on an FTTN or FTTB nbn connection with Lightning IP."
url: "https://www.lightningip.com.au/help/internet/setup-d-link-dsl-2888a"
canonical: "https://www.lightningip.com.au/help/internet/setup-d-link-dsl-2888a"
updated: "2026-11-19"
---

# Setting up your D-Link DSL-2888A

How to set up a D-Link DSL-2888A modem on an FTTN or FTTB nbn connection with Lightning IP.

The D-Link DSL-2888A is an older modem router with a built-in VDSL modem. Use this guide to set it up on an FTTN or FTTB nbn connection with Lightning IP.

This modem is fine for everyday use on slower plans, but its older hardware can hold back faster plans. If you're on a faster plan, a newer modem will usually give you better results.

## Settings our network needs

| Setting | What to choose |
|---|---|
| Connection type | Dynamic IP |
| VLAN / VLAN ID | Off (untagged) |
| Username and password | Not needed |

## Set it up

1. **Reset the modem** - With the modem plugged in and switched on, hold the **Reset** button with a paperclip for about 3 seconds. This clears any old settings.
2. **Connect to the phone socket** - Plug the phone cable into the grey **DSL** port and the other end into your wall phone socket. Don't use any line filters or splitters.
3. **Power on** - Switch the modem on with the **Power** button.
4. **Connect a device** - Plug a computer into a yellow ethernet port, or join the modem's Wi-Fi using the details on the label.
5. **Open the setup page** - In a web browser, go to **192.168.1.1** or **dlinkrouter.local**.
6. **Start the wizard** - The setup wizard should open by itself. If you're asked to log in, click **Log In** (there's no password yet). Click **Next** and wait while the modem detects your connection.
7. **If it can't detect the connection** - Set **WAN Access Type** to **VDSL** (or **xDSL**), set **ISP** to **Not Listed**, and click **Next**. Choose **Dynamic IP** and click **Next**.
8. **Set up your Wi-Fi** - Change the Wi-Fi names and passwords if you like, then click **Next**.
9. **Set an admin password** - Choose a password for logging in to the modem, then click **Next**.
10. **Finish** - Click **Finish** on the summary page. Allow up to 10 minutes for the modem to connect.

## If it doesn't connect

- **DSL light flashing or off** - Check the phone cable, remove any filters or splitters, and try another phone socket.
- **Internet light off** - Log back in and check the connection type is **Dynamic IP** with VLAN turned off.
- **Still no luck** - [Restart your modem properly](/help/internet/restart-your-modem) and follow our [no internet connection guide](/help/internet/no-internet-connection-troubleshooting), or get in touch.
