Category: Phone System Admin · Last updated 16 Nov 2026
How to put keys on an expansion module
Set up the extra keys on a phone's expansion module, the side panel of keys used on reception phones.
An expansion module is the panel of extra keys that sits beside a desk phone, often used at reception to see the whole office at a glance. Its keys are set up in the same place as the phone's own keys, they just carry on after the phone's last key.
Before you start
- You need an administrator login for the Hosted Voice portal. If you don't have one, contact us and we'll set it up for you.
- Know your phone model. It decides which key number the module starts at. Check the table below.
- Don't apply a template to this phone unless the template includes the module keys. Applying a template replaces every key, including the module's. See How to use a function key template.
Where the module's keys start
Keys are numbered in order. The phone's own keys come first, then the module's keys carry straight on.
| Phone | Keys on the phone | Pages on the phone | First key on the module |
|---|---|---|---|
| Yealink T57W | 29 | TBC | Key 30 |
| Yealink T54W | TBC | 3 | TBC |
| Module | Keys | Pages | Keys per page |
|---|---|---|---|
| Yealink EXP50 | 60 | 3 | 20 |
A second module carries on after the first: with an EXP50 on a T57W, the second module starts at Key 90.
Add a key to the module
1. Open the staff member's Function Keys tab
In the portal, go to Extension and Trunk > Extension, click the edit pencil next to the staff member, and open the Function Keys tab.
2. Add keys until you reach the module
Click Add until you reach the key number you need. Leave the keys in between as Null.
| Type | What it does |
|---|---|
| Null | Leaves that key as it is. Use this to skip over keys. |
| N/A | Makes the key blank. |
3. Set up the module key and save
On the module key, set the Type (such as BLF), the Value and a Label, then click Save.
The phone and module update by themselves. If they haven't after a few minutes, go to Auto Provisioning > Phones, tick the phone and click Reprovision.
Troubleshooting
- The key showed up on the phone, not the module. The key number is too low. Count the phone's keys and check the table above.
- Some phone keys went blank. Those keys were set to N/A. Set them back to Null, or set them up again.
- The module is dark or shows no keys. Check the module's cable and power. If it still doesn't work, contact us with the site and the phone's MAC address.
Rather we did it? Contact us with the staff member's name and the keys you'd like on the module, and we'll set them up.
Related Articles
- Phone System AdminManaging your Hosted Voice phone system: what you can do and when to call usHow admin works on Hosted Voice: the changes you can make yourself, the ones we make for you, and how to ask.
- Phone System AdminExtensions, users and desk phonesHow extensions work on Hosted Voice, what we need to add or remove a staff member, and how desk phones are set up.
- Phone System AdminBusiness hours, holidays and after-hours call handlingHow your opening hours and public holidays control where calls go, and how to switch to after-hours mode early.
- Phone System AdminHow incoming calls reach your team: numbers, menus, ring groups and queuesThe building blocks of inbound call handling on Hosted Voice, and how to decide between a ring group and a queue.
Was this article helpful?
Your feedback helps us improve our support content.