Category: Phone System Admin · Last updated 19 Nov 2026
How to factory reset a Yealink desk phone
Reset a Yealink desk phone to factory settings so it reconnects to your phone system, and what to do if it asks for a PIN afterwards.
A factory reset wipes a Yealink desk phone back to how it left the factory. When it starts up again, it fetches its settings from your phone system and reconnects by itself. It's a good fix for a phone that's stuck, or one that's moving to a new staff member.
Call us before you reset. Some older Yealink phones ask for a PIN after a reset before they'll reconnect. Ring us on 1300 994 884 first, and we'll make sure it comes back online smoothly.
Before you start
- A reset removes anything saved only on the phone itself, such as personal contacts, ringtones and backgrounds. Keys and settings from your phone system come back automatically.
- Make sure the phone is still plugged into the network, so it can reconnect after the reset.
- If the phone just needs a restart, unplug the power cable (or the network cable, if that also powers the phone), wait 10 seconds and plug it back in. That's often all it needs.
Reset the phone
- Hold the OK key Press and hold the OK key in the middle of the arrow keys for about 10 seconds. On some models, hold the Redial key instead.
- Confirm the reset When the screen asks Reset to factory setting?, press OK (or tap OK on a touchscreen).
- Wait for it to restart The phone restarts by itself. It can take a few minutes and may restart more than once.
Check it worked
The phone shows the staff member's name or extension on the screen, and you can make a test call.
If it doesn't reconnect
- It asks for an RPS PIN or says to contact your service provider - Call us with the MAC address from the label under the phone. Each phone has its own PIN, and we'll give it to you.
- It shows "No service" or "Configuration updating" - Give it a couple of minutes. It may restart again on its own.
- It asks for a username and password - Don't enter anything. Contact us with the site and the MAC address from the label, and we'll get it connected.
Rather we did it? Contact us with the phone's MAC address and we'll walk you through it.
Related Articles
- Phone System AdminManaging your Hosted Voice phone system: what you can do and when to call usHow admin works on Hosted Voice: the changes you can make yourself, the ones we make for you, and how to ask.
- Phone System AdminExtensions, users and desk phonesHow extensions work on Hosted Voice, what we need to add or remove a staff member, and how desk phones are set up.
- Phone System AdminBusiness hours, holidays and after-hours call handlingHow your opening hours and public holidays control where calls go, and how to switch to after-hours mode early.
- Phone System AdminHow incoming calls reach your team: numbers, menus, ring groups and queuesThe building blocks of inbound call handling on Hosted Voice, and how to decide between a ring group and a queue.
Was this article helpful?
Your feedback helps us improve our support content.